Click to See Complete Forum and Search --> : Network Setup Wizard Problems


nir0c
10-15-2003, 10:10 PM
Whenever I run the Network Setup Wizard I get this error when is at the end bit configuring...

Cannot Complete the Network Setup Wizard

An error occurred during configuration of the network on this computer

You can configure the network manually, or you can run the wizard again with different settings.

So I've changed a few things and it still happens. All I am trying to do is to configure my other computer to connect through this computer to the net. Any advice or help would be helpfull. Thanks....

nir0c

Greenstead
10-16-2003, 10:14 AM
See here:
http://support.microsoft.com/default.aspx?scid=kb;en-us;291867&Product=winxp

But you don't really need the wizard.

Just ensure all NICs are set to get an IP address and DNS address automatically and then enable ICS on the dial-up connector.

nir0c
10-17-2003, 03:06 PM
Ok. Done that. But when I enable ICS it comes up with this error:


Cannot enable shared access.

Error 1003:Cannot complete this function.

Also I get "1061" Instead of "1003" if I try again. I don't know what's going on...

Please help... Thanks...

nir0c